[SATLUG] fstab help
Todd W. Bucy
toddwbucy at grandecom.net
Tue May 19 11:08:59 CDT 2009
thanks I will try to add it to my rc
On Tue, 2009-05-19 at 11:00 -0500, John Pappas wrote:
> If this is a USB device, you can add a custom UDEV entry so that when the
> device identifier used is discovered (SerialNo, ManufacturerID/DevID, or any
> other valid ID) that command is run by UDEV.
> Ref: http://www.reactivated.net/writing_udev_rules.html
> Now looking at that command, you may be able to add it to your RC init
> sequence (rc.local or the like) so that it happens when you boot.
> On Tue, May 19, 2009 at 10:19, Todd W. Bucy <toddwbucy at grandecom.net> wrote:
> > hey all I need some help with my fstab. I have been using the following
> > command to get my Garmin GPS up and running.
> > sudo mount -t usbfs none /proc/bus/usb
> > however typing out this command every time I want to use my GPS
> > inconvenient. Can some one give me a hand with the entering this into
> > my fstab. I can't seem to get the syntax right.
> > Thanks
> > Todd
> > --
> > _______________________________________________
> > SATLUG mailing list
> > SATLUG at satlug.org
> > http://alamo.satlug.org/mailman/listinfo/satlug to unsubscribe
> > Powered by Rackspace (www.rackspace.com)
More information about the SATLUG