[SATLUG] ipv6 problems

Don Davis dondavis at reglue.org
Sat Sep 4 15:15:08 CDT 2010


I recently set up a bridge device. I had done this in the past with no
problems. It seems to work fine with ipv4. However, I prefer to use ipv6
on my lan.
With br0 enabled I can ping6 the outside world, but cannot find the
laptop on my network (using it's wan address). 'no route to host' is the
message I get. However, if I first establish an ipv4 connection, I can
then connect using ipv6.

How can I fix this?


More information about the SATLUG mailing list